Page 1 of 1

Looking for a trader to help

PostPosted: Thu Jun 15, 2017 11:18 am
by Tinman
Hi,

Bit of an unusual question, but I'm hoping you can either help or put me in touch with someone that can. I'm working on a project for a stage production of a major Hollywood movie, so I can't go in to too much detail for non-disclosure reasons.

In a nutshell what I'm looking for is a company that can print my model aircraft design and then cut it from 6mm depron, basically leaving me a kit a bit like that of an indoor shock flyer. The size of the biggest piece is approximately 1250mm long by 650mm wide.

So far I have made a couple of prototypes by hand and test flown them etc, so the next stage is to produce a more final design for sign off, before then commissioning a print of around 700-800 ish.

I hope you can help.

Re: Looking for a trader to help

PostPosted: Thu Jun 15, 2017 1:44 pm
by Dave Wilshere
Talk to Hacker in CZ

Re: Looking for a trader to help

PostPosted: Wed Jul 05, 2017 12:25 pm
by Tinman
Cheers, managed to find a chap in the UK while at Weston.